Help with Door Panels

[LinuxNative]

How do you remove the door panels on a NBS? I'm affaid I'm gonna break something if I just tear into it.

[Eric Guidry]

Remove the trim piece around the inside door handle {Snaps off} then remove the switch pannel{snaps off} unplug the wires then by the inner door handle there is one or two screws {been a while dont remember} remove them, remove the plastic sail pannel {snaps off} that covers the bolts for the outside mirror. Grab the pannel and lift straight up and pull out slightly at the same time! Dont forget to unplug the light at the bottom of the pannel! Take your time they are easy to remove and good luck! If i forgot something it is minor so keep your eye out!

[LinuxNative]

Remove the trim piece around the inside door handle {Snaps off} then remove the switch pannel{snaps off} unplug the wires then by the inner door handle there is one or two screws {been a while dont remember} remove them, remove the plastic sail pannel {snaps off} that covers the bolts for the outside mirror. Grab the pannel and lift straight up and pull out slightly at the same time! Dont forget to unplug the light at the bottom of the pannel! Take your time they are easy to remove and good luck! If i forgot something it is minor so keep your eye out!

Thanks! You were a great help. I got it done.

Thanks again! :rocking:

[Eric Guidry]

These pannels are easier to remove without those stupid pins that GM used to use and would break easily! :FSCrules:

[popknot98]

does the nbs panels have the same ring around the door handle thing that is always breaking?? i can never seem to get it off very easily on my 98, its a bish ta do.

[LinuxNative]

Nope. Just 2 screws, and you just lift up on the panel. It's easy! I was just being a sissy about it.