Question for UR2HI

[Rollindubs]

Okay man when u relocated your fuse relay center did you have to move the wiring harness that is down on the firewall? How did you go about this. Cause im working on prepping my front up to lay it and this part is boggling my brain.

[Kruznlow]

heres what i did... setup my fenders for bodydropping.. need to finish grinding and them seam seal it but worked good for me.. a bit of dinking around bout i wont have to when i bodydrop it..

[Rollindubs]

what did u do there just move it over? and where did u put the relay center box?

[ur2hi]

it has to be moved. i just pushed it thru to the other side of the firewall. problem solved

[Kruznlow]

what did u do there just move it over? and where did u put the relay center box?
yup just un pluged the bottom large plug (torx screw in ctr of plug) and the top harness's jsut unplugged them at wiper motor, cruise, light harness's ect..

BTW truck wont run without the cruise hooked back up!!!




it has to be moved. i just pushed it thru to the other side of the firewall. problem solved

i'm guessing you mean have the whole relay center in the cab under the dash right? i haven't even looked at my relay center but how hard is it to disconnect all the wires to get it through a grommet? have any pics of what your talkin about?