View Full Version : Putting super pivots on line bars?
03-28-2008, 04:52 PM
How should i do this? We are kinda building the link bars and need to cut the bars to the right length and weld them on. Meh screwed the thread title
03-28-2008, 08:13 PM
try measuring your end links center to center...I can't think of how to word what i'm thinking of lol I'm sorry... Get your measurements from your frame/x-member to your axle, then weld up your bar ends so the center to center measurement matches that - i think... good luck dude!
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.
SEO by vBSEO