mc7719
05-05-2008, 10:17 AM
Alright, I have been all over the interior of this thing and sure the newer, rounded dash looks pretty an all.. but try finding a flat section to mount a CB!
Where have other guys mounted this thing in the cab? Mine's a regular cab. The CB is a RadioShack special, small unit I got for free....
First place I thought of was vertical mount on the ashtray panel. I don't use it anyway. However, in order to screw through the panel, you have to remove the actual ashtray part from the inside. Well that part also has the clip to keep it closed. So that doesn't work, however I may re-visit it.
The best place I found to screw the bracket to was the section of plastic UNDER the power outlets. The CB sits perfect, low and out of the way. All seemed fine, was just about to drill the holes trying to get around the shifter (its manual trans). Oh wait. The shifter. Plugged the mic in the front of the unit, lined it up again, and the shifter hits it and so won't shift into 1st gear. So that location is out and now I'm stuck.
I wanted to keep it subtle, clean, and out of the way. I'd also like to avoid drilling holes in the main dashboard, rather in a panel or piece that's easily replaceable (Should I ever remove it)
Ideas?
Where have other guys mounted this thing in the cab? Mine's a regular cab. The CB is a RadioShack special, small unit I got for free....
First place I thought of was vertical mount on the ashtray panel. I don't use it anyway. However, in order to screw through the panel, you have to remove the actual ashtray part from the inside. Well that part also has the clip to keep it closed. So that doesn't work, however I may re-visit it.
The best place I found to screw the bracket to was the section of plastic UNDER the power outlets. The CB sits perfect, low and out of the way. All seemed fine, was just about to drill the holes trying to get around the shifter (its manual trans). Oh wait. The shifter. Plugged the mic in the front of the unit, lined it up again, and the shifter hits it and so won't shift into 1st gear. So that location is out and now I'm stuck.
I wanted to keep it subtle, clean, and out of the way. I'd also like to avoid drilling holes in the main dashboard, rather in a panel or piece that's easily replaceable (Should I ever remove it)
Ideas?