Dual Side Exit Exhaust?

[SierraDan]

I want to have my Echo Chambers exit in front of the rear wheels instead of over the axle out the back. Is it possible to hook up a second stock y-pipe then just run 45 degree bends to have the pipes come out the sides? I'd have to move the hangers but that's no big deal. I just want to know if it would fit around the gas tank.

If it's too much trouble i'll just run the exhaust out the back and save up for sidepipes when I build a new motor.

[Quyonmob]

You want one out each side? Will be tough on the drivers side with the gas tank.

I ran a single 3" out pass side. Easy room for two on the same side, A little tight with where the drops for the cab though.

http://i80.photobucket.com/albums/j195/Quyonmob/92%20BLUE/DSC00727.jpg
http://i80.photobucket.com/albums/j195/Quyonmob/92%20BLUE/DSC00888a.jpg

[Underpowered]

your gas tank will be in teh way, but many, including myself, have just ran two pipes out one side before the rear tire. i ran dual 3" tips at a 45* angle out infront of the passenger side rear tire.

P.S. your sig is way to big. max size is 500x200

[SierraDan]

Ok thanks, I figured the tank would be too big. I guess i'll just run it out the back like originally planed.

And I also figured the sig was kinda big, do you know how to cut off the top and bottom of that pic so it's just the truck? And maybe trim the sides a bit too if needed. I'm stupid and can't figure out how to do it myself, that's just how it was when I uploaded the pic.