View Full Version : new trans temp gauge dosn't work
01-22-2009, 06:12 PM
Well I just bought a Escalade overlay and one stepper motor and buld and I got everything disassembled easy, marked all the needles and soldered the new motor in and I know its installed corectly because it can only go one way and all the points are covered. And I noticed the bulb that I got has a blue housing and I noticed the other gauges have yellow and the ones with the blue are my warning lights. Is this why my light dosn't work or do I have to reprogram my cluster the make the motor work? Sorry for the long post anything helps.
01-24-2009, 06:45 PM
01-24-2009, 07:12 PM
From what i've read, the gauge has to be 'enabled' with a programmer. Don't know about the light.
01-24-2009, 07:14 PM
does anyone know if I have to go to a dealer or can a handheld do it? Thanks
01-24-2009, 07:15 PM
This guy on Ebay does repair work-where I found my info.
01-24-2009, 07:31 PM
Thanks I will send him an e-mail
01-25-2009, 06:52 AM
That guy said $120 to just reflash the cluster and he said it will only take a few minutes. That is highway robbery.
01-25-2009, 05:28 PM
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.
SEO by vBSEO