Do any of you guys...

[BigChevMan]

Make your own circuit boards? What program do you use to design them? I'm working on a custom circuit board and I'm stuck as to what program to use.

[Funk]

visio 2002 it does networking and circuitry

[Shawn]

Havent done it since college - just wondering, since you guys are fabricating ckt boards, are either of you enrolled in elec. engineering programs?

[BigKID]

I used Electronic Workbench and Pspice when I was at school but have not used it since then. I dont even have them on my computer anymore. The newest version of Pspice should do anything you need from simple circuits to logic chips.

[Funk]

I spent almost two years in EET before switching to networking.

I used electronic workbench while I was in EET, but it was on my old computer and not my new one.

[Shawn]

Cool, I have an AS in EET. Had plans to go on for BA but landed a good job, and never did.

[Vince]

I used to use PSpice in school also. Back before I got smart and switched out of EE. It was a pretty easy program to use. Very user friendly, if I remember right. But, I don't always remember stuff from those years real clearly... :drunk: