NBS center console

[kirk]

Ok, so I've been looking at putting a stock center console in my 01, but I need a couple measurments before I order one.
1) How far is it from the front bolt holes on the mounting bracket to the front of the console (just the big floor piece itself)
2) How far is it from the rear bolt holes to the back of the console?
3) Do all of them have vents and storage pockets and all that crap on the back of them?

Edit:
I guess the console I looked at was for a 99-02. The one that's like two separate pieces. That's the one I need measurments for.
And AFAIK, all the 03+ consoles were one big piece.

[Loose Nut]

I just picked up a `02 with rear audio controls, but no vents. I can measure this stuff for ya when I clean the crud off the parts.

Do you need the lower dash piece? I got an extra that I found out I didn't need since my factory dash cup holders use the correct part, so I already had it.

[Loose Nut]

7.5" to the front hole (on center), 7" from the back to the first of the two back holes (also on center).

Let me know if you need anything else, because this is going in today (friday).

[kirk]

Awesome, thanks man. Exactly what I needed.
I don't need a lower dash piece, the console I'm looking at getting already has it. If I even use that piece though, I'll have to do a lot of modifying so my shifters can come through (5 speed truck, and floor shifted transfer case).

[Loose Nut]

Yeah, I almost seriously contemplated a NV4500 swap since I found a tranny for 400 locally, but then my knees started acting up again due to the weather and I remembered I'm a semi-gimp. lol God, I miss having a manual. At the same time, my knees are trashed, so it would probably just cause me a lot of pain (literally).