transgo kit shifts little hard

[Josepht85]

I have an 06 ccsb 1500 4x4 with a 5.3 and 4l603. I put a transgo hd2 kit with a vette servo in the tranny. The seperator plate is drill .082 i believe. My question is, i like the quickness of the shifts but they are a little harder than what i like. My question is can i leave all of the stuff from the kit in tranny and change the seperator plate to one that is drilled smaller to reduce the firmness or would i need to take all the shift kit stuff out. I just want it to shift quicker but not snatch quite as hard. thanks

[NEUMANNZZ]

how many spacers did you put in the accumulator housing? if any remove them.
custom tune installed? if so get a retune to modify line pressure settings(ie lower them)

[Josepht85]

No spacers were used. I have a blackbear tune, and justin said he has already turned the pressures below stock settings. Would it hurt to turn them down just a touch more, actually 1-2 gear change is good, 2-3 is what is a little firm. And if i'm wot from whatever gear it downshifts too back to drive is a little hard but i don't mind that. I guess the best thing would be is to get justing to turn the pressure on 2-3 change down a touch.