Brake/turn signal problem

[boyer61]

Hey guys, i just bought a nice looking 84 K10.

Drove it home and found out my right turn signal or brake dont work! I replaced the bulb. the forth works like it should. It's getting 0 volts when it should be getting 12, so i know theres a break somewhere. What would be the best way to figure this one out?

I know one wire is ground, one goes to the parking lights, and one goes to the brake/turn signal. Where should i look first?

[jt1200r]

check your connections.should be one about center of the bed. i had a bad one plus the lead **** on the bottom of the bulb werent making a good connection

[boyer61]

Will check that out! Thanks!

[boyer61]

Looked under the bed, hack job from hell, im sure the problem lies in there.

[boyer61]

Well this morning i fixed the wire, crimped and heat shrinked it. The turn signal did work, so i just assumed the brake light would work.

Went out to check it just now and it's not working at all. I'll make extra sure the wires is fixed tomorrow.

[boyer61]

Alright, they work now.

I do have another issue..

With my headlights or parking lights on, my turn signals wont work, both front and back. I DID PUT LED'S IN THE REAR. But they have resistors built in and all that good stuff. What could be the issue?