5.13 10 bolt front

[GreaseDog]

i have a 5.13 geared 10 bolt front with 30 spline inner axle shafts, good gears, open differential, good ujoints. setup for crossover steering with steering arm. at this point i have no outers for it, just a knuckle to knuckle axle. if you would purchase this axle, you would only need to put the outers of your choice on it to be ready to go. gears professionally set up. going a different direction with the truck, so i no longer need it. asking $300 OBO

[GreaseDog]

bump

[helo]

(edit) n/m, going a different direction (not looking for spare 10 bolt shafts anymore, stepping up to a D60 I found on pirate)


Willing to part it out further?

Is it a machined dana44 knuckle, or aftermarket? What style joint is the crossover steering arm set up for?

You don't happen to have the 3/4 ton caliper brackets, do you? (gotta ask.. I'm almost ready to hack&weld 1/2 ton brackets to fit 3/4 rotors)

[GreaseDog]

bump sorry for the missed post. glad to hear you found a 60 though.

[GreaseDog]

bump

[GreaseDog]

bump

[Tahoejoe99]

I am semi interested in this. This is a chevy low pinion 44 right?

[GreaseDog]

PM sent, and its not a low pinion 44, its a GM 10 bolt front.

[Tahoejoe99]

I am interested as well. sorry not fam with the 10 bolt front. What side is the pumkin on? And what is the diff between the GM and Dana 44 for chevy?

[Dixie]

You still have this, Greasy?gp

[GreaseDog]

yup, sure do, though tahoejoe has been texting me about it. nothin set in stone yet...

[Tahoejoe99]

sorry man no funds till possibly end of this month to the middle of the next

[GreaseDog]

bump

[GreaseDog]

Parting out

[GreaseDog]

bump

[GreaseDog]

Bump

[GreaseDog]

Bump