CrossFit2500
11-24-2011, 09:48 PM
Not sure if I am asking this in the right part of the forum but I believe I am.
My 92 Silverado 2500 is 'tipping' to one side. I realize one of my cab mounts is 'gone' So I ordered a new one from LMC. So it came I went under the truck, put my impact wrench on the old bolts and it just 'spins' like a weld nut is broken. Ok, no problem I can run a welder and have one in my shop. My question arises ...Do I have to go to the weld nut through the interior of my truck, meaning do I have to pull the seat out, and carpeting out to get to it? Hopefully NOT!!!
Thanks for any input...
My 92 Silverado 2500 is 'tipping' to one side. I realize one of my cab mounts is 'gone' So I ordered a new one from LMC. So it came I went under the truck, put my impact wrench on the old bolts and it just 'spins' like a weld nut is broken. Ok, no problem I can run a welder and have one in my shop. My question arises ...Do I have to go to the weld nut through the interior of my truck, meaning do I have to pull the seat out, and carpeting out to get to it? Hopefully NOT!!!
Thanks for any input...