building of a mud truck

[yukongt454]

ive got a 2 door 1997 tahoe that im making a mud truck. it has the vortec 350 that ive rebuilt but i want to do a cam and maybe higher compression (it will be carburated) i need suggestions i want to run about 400hp it been bored .030'' over i will be using a turbo 400 tranny and np205 transfer case and dana 60s front and rear. im doing motor first so i need suggestions

[speedjunkie]

I would do a carb then. If you are running a t400 then it will work better. The induction system is what held the vortec back.

[yukongt454]

yah im planning on it

[yukongt454]

what should i run to limit my fuel pressure because it has a 60 psi fuel pump and a carb needs way less.
should i do a different fuel pump or is there a pressure regulator that will work

[lightemup01]

8-12 pnds fuel pressure (roughly) and holly red regulator from autoparts store also will need hei distributor and heads machined to fit carburated intake.

[yukongt454]

Can you give me parts #s or links for these parts i already got a vortec high rise intake, and an msd hei distributer.
im also hoping to run proform 66915 rocker arms and i have been looking for at this cam GM Performance 14097395 i have been worned about the amount of lift i can put with vortec heads do you have any suggestions. i also have zoomie headers