front speed signal missing error after front suspension modifications

[i3owdown]

its been a while since i bagged the front of the tahoe. i am just now recently getting around to driving it a bit but check engine light threw 2 error codes. b0226 and b0222. left front speed signal missing and right front speed signal missing.

when i bagged the front, i swapped spindles but i pulled the original dust plate with sensors and swapped them over to new spindles so im not sure why its picking up this error. could it be that my wheels are now .75" smaller in diameter than stock? any thoughts?

[lowlife113]

mine did that too i have been told that when your taking the sensor out and putting it in you need to be very careful cuz if theres and power left in the system you can ground it out so im guessing either that or it got greasy touching it i havent fixed mine yet

[i3owdown]

mine did that too i have been told that when your taking the sensor out and putting it in you need to be very careful cuz if theres and power left in the system you can ground it out so im guessing either that or it got greasy touching it i havent fixed mine yet

i dont know how much truth is behind that though. if you think about the location, its prone to constant brake dust and grease. its also comes in contact with water as it rains in which case if it were that sensitive, then it would ground out with the water. there has to be something else. i dont think i would have damged both of them, i didnt really touch the sensors, only the plates.

[lowlife113]

i mean you never know though it has to be something what are the odds that both of ours through the codes right after doing the spindles