Need help picking valve covers.

[BlacK20]

well, im going to be swapping my Performer RPM to a Victor on my orange truck. figured i might as well pick out a set of new valve covers at the same time

here is what i have it narrowed down to, i really like the retro looking ones cause they go with the theme of my truck (Carb, rally's, etc)

anyways, any thoughts? anyone used any of these?

Fab'd aluminum:
http://www.summitracing.com/parts/SUM-440605/

Retro style:
http://www.summitracing.com/parts/TRD-6607/?rtype=10

Current engine and truck setup:
http://i668.photobucket.com/albums/vv44/Low_Orange/DSC_4909.jpg
http://i668.photobucket.com/albums/vv44/Low_Orange/DSC_5071.jpg

[SUBURBIAN]

The fabricated aluminum covers will look out of place. Go with the finned covers...they're pretty sharp looking. Hate me if you want, but I think you should paint them orange, and leave only the fins showing shiny aluminum. That would look great IMO.

[ryan_thompson87]

Agree'd, never really been a fan of the fabbed ones.

[LeoP]

finned here too.

[BlacK20]

im thinking im going finned, just fits my whole "theme"

[BlacK20]

Just hope my roller rockers fit under them

[907 Chevy]

I'd go with the fabbed covers,however I'd get a plain set that isn't polished or anodized and give them a brushed finish. I did that to a cheap set of polished aluminum valve covers I got on eBay and they match the cast aluminum finish of the intake really well.

[dozzey]

what about the Proform slant edge covers lots of room for roller rockers or stud girdles for your sbc. I just changed mine to these with the chevy orange

[94_c/1500]

Between your choices, I'd say finned. Have you looked into Moon eyes? They have cast aluminum valve covers that have 2 breathers to each side. They look really nice.