NBS Ignition Killswitch Help

[BRAPP]

Trying to put an ignition killswitch in my buddys 02. I know that it is a larger gauge pink wire, which is accompanied by a larger white wire? Does anyone have a picture of the wires, which harness they're located in or anything to help me out. I used a light tester on larger pink wires and I cant seem to find the igniton one. By any chance is it in the same harness as the fuel pump?

[mattillac]

If you wanted to install a kill switch on a different circuit then maybe check this document here:http://www.gmupfitter.com/publicat/bull/bull26.pdf

The wire for the passlock is 20 gauge, should be pretty easy to find under the dash and is very low current at around 7ma.




When I forget to close the circuit/switch and attempt to start on mine, the engine will run for 2 seconds and then stall.

[BRAPP]

If you wanted to install a kill switch on a different circuit then maybe check this document here:http://www.gmupfitter.com/publicat/bull/bull26.pdf

The wire for the passlock is 20 gauge, should be pretty easy to find under the dash and is very low current at around 7ma.




When I forget to close the circuit/switch and attempt to start on mine, the engine will run for 2 seconds and then stall.

you answered my next question because I was going to do this on my OBS after I figured out the NBS one. Thanks for your help, but I know he NBS is different. I will use this to help me out on the NBS though! Thanks again