edc question can't get a definite answer

[bodydropped88]

i want to go back to havin a edc for my truck. due to hood clearance with big block i had to somewhat ditch the york. i know this is the expensive way but right now i am not worried about that. i just wanna know is there any reason i can't use this kit for airride? i tried march performance themselves and pretty much got the, " i dunno," answer from them. the compressor is a sanden 7176 i believe. here's the kit #. http://www.summitracing.com/parts/MCH-20360/

[ontarioss]

You could but, you will need to either disassemble the compressor and fill it with grease, or put an oiler on the intake side. You will need a good separator after to collect the oil back out. You could also mount the York on its side to save height? Might not clear the big block though.

[bodydropped88]

nope that's the way i have (had) the york mounted. with a 3.5" trad bodydrop it stuck about 3" or so above the fender and about 6" over to pass side too far even with a cowl hood. i used the gm serp kit and kwikperformance adapter kit.

[custm2500]

You can buy a lot of electric compressors for $2000! Why not just go to 2 or 3 electric compressors and you should have as much if not more air?

[Dev's93]

He prob dont want the slow pump ups and annoying buzz idk about the kit but damn its sexy

[custm2500]

The noise I can understand, the slow is solved by spending much less then $2000 on a few pumps.

[bodydropped88]

that's exactly what it is! loud and annoying! the edc was so much faster but i guess i can always put 4viair 480 compressors or so in. i dunno.
He prob dont want the slow pump ups and annoying buzz idk about the kit but damn its sexy

[Dev's93]

aw hell you gotta big block show it off who needs a hood lol

[bodydropped88]

thought about that, too!