Spintech muffler size questions.

[tdp378]

Im in the market for a new muffler. I was leaning toward a spintech 6000 series. For now, I was just going to try to cut it into my factory exhaust by cutting out the old and putting in the new so to speak. Is this even possible? What size in and out should I be looking at to fit the factory pipe? I dont want to frankinstien some crap together but i am limited on funds at the moment.

[RRLH]

need a little more info to go on.... what year vehicle and engine?

[tdp378]

need a little more info to go on.... what year vehicle and engine?

Right! Sorry im an idiot!

Its a 97 c1500 5.7

[Low97tahoE]

U would need a dual 2.25 in/single 2.5" or 3" out....or a dual 2.25 in, dual 2.25 out

Sent from my HTC One X using Tapatalk 2

[tdp378]

U would need a dual 2.25 in/single 2.5" or 3" out....or a dual 2.25 in, dual 2.25 out

Sent from my HTC One X using Tapatalk 2


Ok Thanks! So the factory piping is 2.25?

[Low97tahoE]

Yep, i think it might be actual 2", but u can't get it in that size, might have to use 2 little pieces of 2.25 pipe to slip over the stock pipe and into muffler, but no big deal, and the stock tailpipe is 2-3/4", so a small piece of 3" would slip over that and into a single 3" outlet muffler if u wanna keep it all stock

Sent from my HTC One X using Tapatalk 2