Swapping to power locks and windows

[gfercaks33]

Are there any write ups on swapping to factory power locks and windows in a 98 single cab?

[ladyzm18]

+1 got a 98 extended cab with no power windows..


Sent from my iPhone using Tapatalk

[gfercaks33]

I get the concept that I need door panels the actuators and the window motors and some harnessss but is the truck wired under the dash.

[BrettD]

I recently did the conversion on my 97 reg cab. If you remove the harness behind the dash below ,the wind shield from the donor truck it will plug right in your convience center down by the e brake release. When you have all parts ready I could take some pics and answer any questions you might have.

[BHB]

http://www.fullsizechevy.com/forum/general-discussion/interior-tech/334001-manual-windows-locks-power-conversion.html

[gfercaks33]

any one have a diagram for this?

i went out to the salvage yard and got 90% of the parts for the swap

i got the door cards out of a suburban with the regulators, motors, and actuators. i grabbed all the lock rods out of the doors, i got the harnesses out of the doors but heres where i hit a snag i got the cross body harness out of the passangerside intact but right behind the gauge (where it goes under a support) it was snagged and i was feeling sick from the heat so i cut it, but i grabbed the pigtails that go into the door harness and all the pig tails out of the convenience center.

i need the diagrams of the convenience center and of the main harness so i can rebuild my harness so i can connect the drivers side door harness to the res of the harness i have and where it goes to plug into the convince center

[gfercaks33]

alright i hope this helps some
http://i229.photobucket.com/albums/ee16/gfercaks33/windowharness.png

i drew this up in paint i need to know what goes where now haha i have it labeled main harness 1 2 and 3 and those are where i had to cut it off so any help will be appreciated. i am assuming half of them will plug into the convenience center and half will go into the cross body harness correct?

also the harness i got this from was from a 4 door vehicle im going to a 2 door will i be able to romove any wires from the door switches to clean this bad boy up?