PDA

View Full Version : 96-98 Engine wiring harness.



1998regcab
12-17-2013, 07:32 PM
I am not sure where else to post this. I am planning on trying to find another wiring harness for my truck so I can do the 0411 PCM swap outside of the truck. then swapping it in when I swap the new motor in. What are the differences in the 96-98 wiring harnesses, if any? And if I do have to find one from a 98 are there any differences in the 98 wiring harnesses that I need to lookout for?

azfansinnc
12-17-2013, 08:10 PM
I am not sure where else to post this. I am planning on trying to find another wiring harness for my truck so I can do the 0411 PCM swap outside of the truck. then swapping it in when I swap the new motor in. What are the differences in the 96-98 wiring harnesses, if any? And if I do have to find one from a 98 are there any differences in the 98 wiring harnesses that I need to lookout for?

Are you planning on doing the 411 swap with the stock motor? If so, I would not want to rip the whole harness out. It really is just repinning the connectors at the PCM and only takes a few hours.


Sent from a can on the end of a string

1998regcab
12-17-2013, 08:17 PM
No it will be with the new motor. I am just envisioning dropping the motor into the truck all put together and figured repining it would be easier on my back done on a work bench rather than leaning over fender.

Massey
12-17-2013, 09:09 PM
The only differences I have noticed was in the Evap system. 96-97 are slightly different than 98-00. The rest of the engine seems to be wired the same.

Dom

1998regcab
12-17-2013, 09:16 PM
The only differences I have noticed was in the Evap system. 96-97 are slightly different than 98-00. The rest of the engine seems to be wired the same.

Dom

Good to know, I will try to find a complete harness next time I am at a yard.