Tips on installing 4 link

[smashingchuck]

Anybody have any ideas on how to get my axle exactlly where it need to be when I weld in my 4 link? I'd likt to leave the leaf spings on when I do it but The mounts are right where I need to weld to the frame. I was thinking of temp. welding the axle to the frame with a brace, and then removing the leaf springs and and putting on the 4 link... any ideas?

chuck

[BigChevMan]

The best piece of advice I can give you is to make sure your bars are parallel to the ground or as close as can be at ride height. I'm assuming your bagging your truck, so I would weld in your bag mounts and then cut a piece of tube or pipe to the ride height of the bag and that will be your axle height...go from there