Going from 2/4 to 4/6. which stock parts needed?

[Bugs]

I have all the parts which came off from my truck when i put the DJM 2/4 drop on it.

I am putting a 4/6 drop on it hopefully this week, and realized i have to put the stock shackles and hangers back on.

Do i use the bolts which hold the DJM stuff on to mount them? Or do i need new bolts?

What all is needed to put the back back to stock? Parts and nuts and bolts etc?

Or if i have my stock shackes and hangers will i be ok?

I dont want to drop it off to be done and find out after i leave the truck for the day that i need Xxx bolt or XXX mounts.

FYI currently DJM 2" LCA + Shackles and Hangers for 4" rear with Belltech shocks

Going to DJM 4" LCA, DJM UCA, and Belltech 6" flipkit with DT shocks.

[Physh1]

To get back to stock just bolt up the stock hangers with the hardware currently there and the shackle should be no problem to do since too with the hardware there. Once the stock shackles and hangers are on the 6" flip kit has all the needed hardware with it for a solid install.

Up front just swap out the 2" LCA's for the 4" LCA's and your good to go.

Good luck, Cameron

[Sevenfold]

:word: I did the same thing, except my stock springs had to go back in before the 4" LCAs were installed.

[Bugs]

thanks for the info guys..

orderring my tires today (if they are open) or tomorrow if they arent today. Need some lower pros for the front. They should be here Monday or Wednesday (the shops delivery days).

So It should go in this week. w00t