Got my IDQ's in

[Robinhood]

OK, I got my IDQ 10's installed. I put them in two seperate boxes (.70 cu ft each) down-firing under the rear seat. I have a TEMPERARY pyramid 600 pushing them. They hit kind of hard, but don't have that breath cutting effect that I am looking for. I know the problem is the amp. Which one would pound the hell out of them? I was told a JL 500/1 and a JBL 600.1 would work good. Any others? Also I have the dvc 4 ohm ones. What I did was wire both voice coil + together and both voice coil - together on the woofer and then wired them to seperate channels of my amp, because the bridging part of it does not work for some reason.

[DSZ71]

Check out this amp, its rated at 525 per channel at 2 ohms, which you could wire your dual 4s to handle a 2 ohm load. Its cheap right now too.

Arc 2500 (http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=3074048390&category=18796)

[Robinhood]

Does my wiring sound ok?

[DSZ71]

It seems okay, at first I was thinking you had wired the subs + to + and then to one channel +, and the other - to- to the other channel -, which would produce a 2 ohm mono load, which is not a good idea, you will damage the amp that way. The way you did it produces a 2 ohm stereo load, so it should be okay!