i got a 350 2bolt main up forsale. im not sure on the year but im going to say its an older block. (has the fuel pump on the side of hte block unlike the 350 in my 91 silverado) it had the machine work done to bored it .040 over and has never been ran. i planned on building this motor for my truck after i got done doing the straight axle conversion to it, but im no longer going to use this block.

machine work was done by local machine shop. i know alot of people that has had machine work done by them and they do an awesome job. never heard anything bad about them. it has eveything to put this motor together except intake, lifters, pushrods, and a cam. i did not take the heads or crank in to get them checked because i wasnt planning on putting the stock parts back in this motor. but if you plan on putting it back together stock i would get the heads and crank checked.

the pistons were ran in another .040 over block for maybe 50 miles and the kid decided to tear the motor apart again and build it bigger. these are just a stock .040 piston and can be cleaned up very easy. machine work was matched to the size of these pistons.

i talked to a few people and they said i should put this up forsale for 400-500 becuase it already has all the machine work done and is ready to be put back together. but ill start it out at 350ob and go from there. its located in midland michigan if anyone is interested. pm me if interested so it catchs my attention next time i get a chacne to come on the website