Just in case some of you guys dont make it over to the project section, check this out.

http://www.fullsizechevy.com/forums/...gen-1-sbc.html

I figured this falls under performance and it will also fall under the tuning section when I get ready to tune it. Its probably going to end up in my truck. I have been wanting MPFI and a roller cam but didn't want to use my edelbrock setup and my block is a non roller. So, I'll just build another motor! I will be using the stock TBI ECM in MPFI mode running $OD

I am going to have to run some major dish pistons to keep the compression down since the chambers are so small on those heads. Cam wise I am looking at a Comp Marine Roller cam.