LinkBack URL
About LinkBacks
Reply With QuoteI used a hydraulic throw out bearing in mine when i put the old 4spd in. Used the stock master, some 4AN line and a RAM bearing, worked flawless. Pedal was real easy.
http://www.ramclutches.com/Products/...se_bearing.htm
|
|
|
This is a discussion on can it be converted? within the Performance forums, part of the General Discussion category; ok so odd question i know, and not sure what i would gain..if any..but, my trans uses the mid stlye ...
ok so odd question i know, and not sure what i would gain..if any..but, my trans uses the mid stlye clutch setup were i have a master, then slave..then fork, pivit ball, and throwout bearing, can i convert mine to the new style..like 2000 on up setups..were they have a hydrolic throwout bearring and jsut a master cylinder...and what gains would be hand in clutch feel and firmness?
92 5.9l full roller,fully forged,scatt crank.AFR 190cc heads,Crane 2032cam,nv3500,S2 6 Puck clutch.Hurst Short Shifter,14-bolt,auburn 4.11.Carbed
I used a hydraulic throw out bearing in mine when i put the old 4spd in. Used the stock master, some 4AN line and a RAM bearing, worked flawless. Pedal was real easy.
http://www.ramclutches.com/Products/...se_bearing.htm
1/4 mile ET 11.77 @ 117 mph
sig by; Chuggs
Originally Posted by 03CCDually
sweet thats good to know ...all i would have to do. is drill to holes in the side of my bell housing. and run lines i may switch to a camaro t5 master as i have heard they give more push.
92 5.9l full roller,fully forged,scatt crank.AFR 190cc heads,Crane 2032cam,nv3500,S2 6 Puck clutch.Hurst Short Shifter,14-bolt,auburn 4.11.Carbed
No need to drill holes, just run them through the fork boot.
1/4 mile ET 11.77 @ 117 mph
sig by; Chuggs
Posting Permissions
 |
Bookmarks