LinkBack URL
About LinkBacks
Reply With QuoteGot 1 from the dealer. He actually gave it to me. Wideband is on the way. Should be here by the end of the week. We'll see how the data logging goes.
|
|
|
This is a discussion on Question about repinning for wbo2 within the TBI Tuning (87-95 / OBD I) ECM/PCM forums, part of the Performance category; 7427 ecm looking to feed wbo2 in the data stream using TunerProRT V5. So I understand about using the pin ...
7427 ecm looking to feed wbo2 in the data stream using TunerProRT V5. So I understand about using the pin location B16 and putting the 0-5volt output from my wbo2 controller there. The question is, do i need a new pin to crimp on or am I able to get a pin from somewhere else in the connector that is not being used?
Got "on" power, ground, tach feed and am staring at the ecm connector wondering about the pin. Dealer isn't open at this time and probably not tomorrow, just because I need it. If I need a new pin, where can I find one? I'd hate to have to wait a week for one to be shipped in. I have no spare ecms either.
Using a "prologger" wbo2 system that I aquired (prologger.com). This thing has more capabilities than I intend to use.
Any thoughts?
Thanks in advance.
Got 1 from the dealer. He actually gave it to me. Wideband is on the way. Should be here by the end of the week. We'll see how the data logging goes.
Last edited by pima.1971; 02-25-2012 at 01:51 PM.
Works good............... after you get it hooked to the correct pin/
Posting Permissions
 |
Bookmarks