LinkBack URL
About LinkBacks
Reply With Quoteit will probably work. just make sure it looks exactly like what you got in the 1500. ie clutch hydraulics are the same for the throwout bearing, length, yoke splines,etc.
|
|
|
This is a discussion on Maybe Ill get a better response here (Nv3500 transmission) within the Transmission Tuning. forums, part of the Performance category; Hoping ill get a better response in this section as apposed to the general section. Ok so I need to ...
Hoping ill get a better response in this section as apposed to the general section. Ok so I need to replace the Nv3500 in my 95 2wd truck my question is im having a hard time finding a trans out of a 1500 but I see one for the s10's all over the place. So the question is will a trans from an s10 with a 4.3 work in my 1500? I've read around and there isn't too much difference but just would like some more reassurance before I pull the trigger.
Zac
1995 RCSB Blue 2wd, 5 speed, 3.42, 350 Vortec swap, and boltons
1991 VR4 White Intake, boost controller, and, full exhaust
1991 VR4 Red Underconstruction
it will probably work. just make sure it looks exactly like what you got in the 1500. ie clutch hydraulics are the same for the throwout bearing, length, yoke splines,etc.
O2 GMC RCSB 4.8L V8 AUTO 3.73's
rebuilt/beefed up 4L60E(at 43,000miles)
Matching Ninja 500r
Any news on this? I'm looking at 3500s right now, not sure the stock 4L60 will hold up much longer... found a couple in the area and I'll likely need a later one with an "internal" slave because I have headers.
'92 Sierra (TBI 383/Vortecs/Comp 08-412-8/EBL/4L60/3.08s), '78 Malibu (Vortec'd 350/4-speed/2.29s), '87 Pontiac Fiero GT (2.8 v6/5-speed)
Posting Permissions
 |
Bookmarks