 |
|
This is a discussion on Putting super pivots on line bars? within the Street forums, part of the General Discussion category; How should i do this? We are kinda building the link bars and need to cut the bars to the ...
How should i do this? We are kinda building the link bars and need to cut the bars to the right length and weld them on. Meh screwed the thread title
Last edited by Ryan P; 03-28-2008 at 04:53 PM.
try measuring your end links center to center...I can't think of how to word what i'm thinking of lol I'm sorry... Get your measurements from your frame/x-member to your axle, then weld up your bar ends so the center to center measurement matches that - i think... good luck dude!
...Never falling victim to "The Norm"...
Posting Permissions
 |
LinkBack URL
About LinkBacks
Reply With Quote
Bookmarks