LinkBack URL
About LinkBacks
Reply With QuoteDrill the hole through what? The cup?
|
|
|
This is a discussion on 90 degree fitting on front bags within the Street forums, part of the General Discussion category; anyone who has 90 degree fittings on their bags up front, what did you use to drill the hole?...
anyone who has 90 degree fittings on their bags up front, what did you use to drill the hole?
Last edited by silverado96; 04-18-2008 at 07:13 PM.
Drill the hole through what? The cup?
** Signature image removed by FSC Staff for exceeding 500x200 limits**
I just used a drill bit a little bigger then 1/2"..whatever I could fit in the drill press. Just make sure you know how the cup will sit if your bottoms are welded in..then drill accordingly so the line comes in on the opposite side of the cup from where the fitting is.
2000 Tahoe
24" Boss 330, 295/35/24 Nittos , 3/5 drop
6.0 LQ4 swap, BB 93, Magnaflow, e-fans, CAI, Built 4l65e, Yank TT3000 Stall
18" BTL w/ Kicker 2500.1 2703 watts,Optimas,Pioneer 4100 DD, Esky Cluster
make sure to use a grommet too. your air line will love you forever.
...Never falling victim to "The Norm"...
1.5" hole saw bit
i asked suicidedoors to cut it for me
Drilled a pilot hole then used a plasma. Made it about 1 inch
They must have been intimidated by your avatar. I know I would be...With both of those guns...Oh, and you just know they're loaded. You can tell by the way he's running!i asked suicidedoors to cut it for me
...Never falling victim to "The Norm"...
it was definately the guns that persuaded them
Posting Permissions
 |
Bookmarks