 |
|
This is a discussion on Tips on installing 4 link within the Street forums, part of the General Discussion category; Anybody have any ideas on how to get my axle exactlly where it need to be when I weld in ...
Anybody have any ideas on how to get my axle exactlly where it need to be when I weld in my 4 link? I'd likt to leave the leaf spings on when I do it but The mounts are right where I need to weld to the frame. I was thinking of temp. welding the axle to the frame with a brace, and then removing the leaf springs and and putting on the 4 link... any ideas?
chuck
1978 short wide - chopped, bagged, shaved.
[Build Thread]---->http://67-72chevytrucks.com/vboard/s...d.php?t=272219
The best piece of advice I can give you is to make sure your bars are parallel to the ground or as close as can be at ride height. I'm assuming your bagging your truck, so I would weld in your bag mounts and then cut a piece of tube or pipe to the ride height of the bag and that will be your axle height...go from there
Posting Permissions
 |
LinkBack URL
About LinkBacks
Reply With Quote
Bookmarks