first thing you wanna do is get some type of support under the trannyOriginally Posted by TIMSPEED
I beleive that the cross member is bolted the x-case and there are only 4 bolts between tranny and x-case(atleast that is the way it is on my truck)
make sure you get all linkage and wires disconnected from tranny and x-case
This is probably going to be messy btw
The first thing I did was put a jack under the tranny to take the weight off and then pulled the cross member. then x-case. then tranny. thats what I did atleast.
I hope this helps