[RnuovZ71]

I have finaly collected most of the parts I needed to start the SAS on my 92 ECSB Chevy. This next week I will be getting my springs in along with all the stuff for my hydro steering. Tomorrow I'm going to order my detriot lockers and 4.56s front and rear. it should be 9" in front and 8" in the back.

What I would like to have done still Is get the bed sprayed w/ rhino liner(or the like), I would also like the have the quarter panels rhino lined. Then I need a new motor. The list goes on with odds and ends, but It will slowly come along.

This is the list of stuff I have so far...

78 dana 60 kingpin front.
87 dana 70 rear.
ORU SAS kit +6" in spring length.
16x10 cast black procomp rims.
Kingpin rebuild kit.
New pads/ shoes for the brakes.
new ujoints for the axle shafts.
37x13.50 mickey thompson Baja Claws.
4.56s Front & Rear.
Detriot lockers F/R.
Hydro steering stuff.
Draglink.
Steering arm.
Tie rods.
Brake lines.
Hub Bearings.
Ubots and Ubolt plates.
Ujoint rear axle.


List of stuff I still need...
Front driveline.
Shocks.
Time, time, time and more time.
I know I'm forgetting a few things but oh well...

BTW the stock gears and carriers out of the front and rear axles need to go. The D60 front has/had 4.10 I think 50+ shipping is fair. The D70 Rear has/had 3.73s 50+ shipping. The stock 3.73 from the 10 bolt rear and front, I need to get rid of also. I need some room here in my shop, If there is anything you need PM me I may have it.