- Where is the Fuel regulator?
- what year LT1 fan do I need
- Turbo for an s-10
- Timing Question
- Big Block?
- Traction Button on GMC's
- Passing gear getting stuck
- Fan help
- compression
- 02 ls6 cam in a 5.3 questions?
- Headers.......
- TBI crate + mods.....how will it work?
- e-fan wiring?
- Silly thought about electric fans and performance.
- cam questions
- Gibson Headers question
- Edelbrock MPFI
- Jet Perforamce Chips
- Swapped LS1 in 2002 ex cab
- what if????
- best late model headers
- LS9 Questions (350 - 85 GMC 3/4 ton)
- V-8 swap from a 4.3L
- Need some advice with a 94 4.3 TBI engine
- Collapsed Lifter
- AIRAID now making drop in replacement filters!
- Free Mods for 97 Chevy 350
- Descreen
- any one have the tbi intake from holley
- 383 from scratch...
- Does anyone have a Pro Flash programmer on an OBS 350?
- diablo on 2 trucks?
- Anybody done a LT-1 swap into a S-series yet?
- Exhaust leak on right bank...
- Lean fuel code help
- question about headers...
- Thermostat
- SPE Pro-Flash numbers
- Reset computer??? Do I need to
- Ok.. so I want to build up a performance engine... SLOWLY..
- good head
- ls1 fan question
- timing help
- timing help
- Need some advie on a 5.3
- Shift kits
- what should i do motor wise?
- Rate This Head
- quick question
- sticky gas pedal
- 8 fricking hours to install Gibson shorties!
- tranny slippin????
- Ignition systems
- Anyone need some P&P'd 5.3 heads? Come in....
- need advice on cam
- $3500 to spend help!!
- 202 heads
- nitrous question
- cam
- Programmer with 2003 6.0
- Tbi
- mixing synthetic?
- Differential shopping
- Throttle Body Spacers
- horsepower differance
- horsepower differance
- ? Throttle Bumpstop Mod ?
- Power-aid TBI spacer and edelbrock performer Intake!
- Which do u guys recommend?
- Descreened MAF sensor now what should i do?
- ANyone use a Holley TBI unit?
- Chip.
- Trans Ideas
- LT-1 computer wiring harness. Pin to plug
- dyno or SOTP improvement w/ 4.8 and power programmers
- Help with gear ratio & rpms
- Any updates on programmers??!!
- electronic CounterAct Corrosion Protection
- where to start on my project truck??
- Throwing Idle Air Control Code
- Performance Upgrades - Exhaust
- Eldebrock Performer Intake Manifold
- TBI mod questions?
- Truck is running cold
- help with my 89
- OK, need help with performance mod....
- tps voltage
- ram air
- K&N Drop in question
- injector question...
- Gas Mileage
- Knock retard help needed.
- What can i do to have more power on my 6.0l
- K&N FIPK For a 2003
- check eng. light code?
- HP Gains?
- Predator
- LT1 Fans. best way to wire up?
- 5.3 vortec mod help.
- hpp codes
- Air intake fitting question
- Question about warranty issues....
- anyone get SES because of K&N?
- HPP3 and Airaid intake worth buying?
- Where can I get 5W-50 synthetic oil?
- Torque Convertor Selection
- 2003 silverado 4.3
- Dayco TC's
- Denalli Engine Cover Problems
- civic?
- holley stealth ram?
- Help for Exhaust Setup
- got some new goodies for my truck
- anyone have problems or not happy with their UPD?
- Help
- I Need Horsies!!!!!!!!!!!!
- descreening
- Setting TDC
- Where to set timing?
- Finally got the Denali Engine covers
- auburn mini spool?
- Trans Am cam swap
- Engine swap
- Proflash Programmer?
- SPE Pro-Flash with cooler t-stat
- Should i run with or without airbox lid?
- 4L60E troubles
- Cam for 94
- possible problem with tranny HELP
- Who provides your spark?
- where do you get tha clear intake pipes???
- transmission
- jet carbs
- wiring for dual electric fans
- Good engine mods
- WOOHOO Its RUNNING
- SPE Pro Flash info!!
- modifying TB....
- What Size Injectors????
- HPP3 Question.
- 4.3L Engine.
- want 14's
- Suggestions?
- What happened to my Auburn Posi
- alternator conversion kits
- magnalfow on a 5.3?
- Thorley Headers: Anybody got them?
- air intake ideas for TBI
- Diffuser Plate?
- UD pulleys
- Radiator Hose needs modified
- Whats going on with my intake system?
- thorley's
- LOOK!!! *** Interest in new Vortec Intake!? ***
- got L98 corvette alum. heads..
- Hypertech or Fastchip?
- Iron L98 Casting Numbers
- Free mods
- edelbrock intake
- 2003 Predators will be released next week!
- Help With Tb Spacer Install
- 160 thermo?
- Anyone see this? Cryogenic Intake Technology: The Future Of Power
- Need info on LS1edit
- Gettin Exhaust today but have a question
- o2 sensor
- Best performance mods for 96+ Vortec 5.7 liter motors?
- coil voltage
- Rough Idle
- fuel cell mounting tips or no-no's
- Experience with Predator and 6.0?
- custom air cleaner housing setups
- 1989 350 tbi specs
- Transmission?
- Brake Question...
- noisy 5 speed?
- Getting headers! need advice asap
- Fullsize chevy engine swap
- Getting a cam
- DiabloSport Predator for 2003 GM Gas Trucks - RELEASED!
- 4L80E Shift Kits
- True Flow air intakes??
- Bolt-on kit for LS1 in 94?
- need some power mods.
- is it worth it
- diesel
- HPPIII Help
- Catback Exhaust advice?
- stock tbi heads vs L98 heads
- chip
- possible I lost performance from intake?
- Yank TT3000 install?
- Borg Warner T-56 in a GMC?
- ATTN: 4.3L Guys!
- Pro Toplines Vortecs
- HPP3 settings
- 4.3 5speed s10
- Headers
- where do i find replac. eng?
- Granatelli MAF Sensor
- cold air intake
- Couple Exhaust Questions
- shake @ idle
- chevy and their soft brakes
- Perma-Cool vs Flex-A-Lite
- The blue menace is running rich and burning oil....
- ASAP!!! INFO!! on HPP3
- pulleys
- Why does my SPE Proflash suck?
- What to torque crank pulley bolts to?
- 96 - 98 throttle body mods
- Wanting to do ignition system up-grade...suggestions??
- Any gain from cutouts
- Suggestions to Increase MPG ???
- TB Spacer
- TB Spacer
- Anyone here do a oil filter bypass???
- Replacing the fan on my 2000
- 4 x 4 to awd need help please
- HPP3 question about Stat
- Electric Fans?
- Which Intake?
- caprice tbi engine
- doh!! need mods!!!
- Gutting my cats tonight?
- 02 Duramax programmer.
- rings or guides
- Cigarette Lighter Fuse ????????
- Vortec timing gears
- Nice Gains!
- valve cover caps
- 5.3L build-up
- HT383 in 96 gmc
- Pullies Or Hpp3
- Z71 performance mods?
- HPP3 setting....need help!!
- carb advice
- Got a 03! Dyno #'s and pics!
- Chrome Valve Covers
- B&M ShiftPlus Electronic Shift Improver
- 15.1/1 A/f
- 377 stroker conversion
- This any good?
- Dynomax headers?
- Power
- Gear Ratio
- Correct way to install an intake?
- Swap..HELP!!!
- Installed B&M ShiftPlus at Lunch!!!
- a fornd farewell