My new indiglo

[landshark]

I finally installed my new indiglo gauges the first pics have the white over the blinkers which I dont like so I then cut them out. The night pics are actually brighter than that in real life.
http://photos.yahoo.com/landshark_40

[Funk]

not bad, I still like my apc's tho with the full white pieces at top and cut outs for the signals

[JB]

Looks good trimmed. Mine should be here any day now.

I have a few questions:
1) How did you trim them?
2) Did you use an exacto knife and template?
3) Can you trim around the message center window?
4) Can you trim around the blank tranny gauge section?
5) Where did you mount the color controller?

Thanks, looks great.

[HENRY]

Yeah good questions.

Also:
1. Can you still control brightness?
2. Does it come with directions on how to remove the dash
thingy?
Maybe you could post some step by steop instructions :)

[landshark]

1. I used and exacto knife and I put the white face gauges against the back and held it up to the light and marked it with a sharrpe.

2. The message center and the blank tranny gauge spot have a wire trace around them so I couldnt trim them.

3. It doent have a color controller just a fade. But I mounted the rotary knob underneath the dash. Because I have it all the way up and use the regular light dimmer to control it.

4. It didnt come with any instructions whatso ever I had to figure every thing out from takin the dash apart to how to wire it. But what do you want for 57 bucks including shipping.

[JB]

Does the white cover go over the existing black one or does it remove? Reason I ask is do you have to trim the black section as well. Also are those the new carbon fiber overlay gauges?

[landshark]

just remove the needles and install the new white ones over the black face and just trim the white. So if for some reason you dont want anymore just remove them. No carbonfiber.

[JB]

Thanks landshark, I hope my installation turns out as clean as yours did.