OBS Yukon Amrest is Loose

[Bad Ash]

So, how do I repair this thing? The drivers side armrest is loose and sags a bit, but I can't figure out how to take it off to repair it. If anyone has any experience with one of these I would really appreciate it! Thanks!

[sack]

any zippers or plastic caps by the pivot point of the arm rest?

if so look inside and tighten the bolt.

but i know on the NBS the arm rest is held in my a clip that you can only access by cutting the material away first.

[JB]

You have to remove the seat cover to access it.

[I rebuildemall]

All the seats with armrests from 95 on have a small c clip to hold it in the seat. You have to unsnap the plastic clips from each other at the bottom of the seat cover back. Once you have it apart push up to the armrest from the front and look into the foam for the clip. Use a oring pick to pull it out of place. Don't loos it in the seat you will be sorry. More than likely either the seat frame is busted(either the bushing or the placement pin) or the pin itself in the armrest is loose. The only way to fix it then is replce the buggered part. I've fixed dozens and most ar the armrest placement pins.