removing inner door panel

[uihockey2]

how do I get this black panel out? I took out all the screws but it is still attached to the window. What is the process for removing the window from the panel?
http://img.photobucket.com/albums/v517/uihockey2/100_1302.jpg

[stimpy13]

Might reivts around the window parts. If not then have to take out glass and tracks. I think just a thought. :D

[kenman1717]

you should be able to push the wheels out of the bottom track on the window, then unhook all the clips from the handle and lock rods, then that panel should come right out.

[loco2355]

By looking at your pic you still need to remove the larger bolt that holds the window guide. It's the bolt on the left side just above the black panel.There is also another for the same window guide on the panel itself.

[mikeyman]

I Might Be Wrong But I Think Your Window Regulator Is Riveted To That Panel. That Would Have To Come Off.

[Zachs92]

it easy, just make sure all screws are out, pull on it. I just did an intaire interior swap and the door were a PITA but well worth it...

[I rebuildemall]

Everyone is on the right rack here. make sure the 13mm bolt is out on the front window track. The regulator is riveted in but does nto need to come off. Pull the top of the card out an inch or so and pop the handle and lock rods out of place and off the handle. Roll the window down about 4 inches and the pull up on the card. There is a tab on the bottom that holds it in. carefull with it, You'll scratch that nice looking paint job. After that you will have to deal with the wiring. If you have a piece of cardboard handy set it between the card and the door the just let it hang. Good luck