quick fiberglass question.

[Low88]

I have a basic understanding of the whole fiberglass process, but I would like to know if anybody has any advice on how to make fleece/t-shirt material stick to my dash piece. I dont want this falling off or cracking.

I know people who have tried to do door panels with little sucess because the whole fiberglassed part ended up falling off. Should I drill a few port holes and resin and mat the structure from the other side as an anchor so to speak?

[cajundragger]

your dash should just be able to be sanded and painted, but if you really want to put fiberglass on it drill a bunch of holes and resin the hell out of it. also go straight to chop mat for this as fleece or t-shirt material will never stick.

[Low88]

I want to mold my three air gauges into my radio bezel where the vents typically are. It is no big deal on my truck, because I have no vents, as my truck must have been the white trash version from the factory.

[cajundragger]

so this is the bezek not the actual dash? if so just rough it up with some 36 grit and go to town..no holes needed.