Bucket seat help in a hurry

[Sailor77]

I am trying to mount 1994 GMC factory buckets in my 91 which has a 60/40. The drivers side bolts right up, no problem. But the passenger side needs new holes drilled. I want to make sure I put them in the right space. Those of you with buckets, where did you drill your holes? Or those of you with factory buckets (ext cab) where are your holes??
I need help asap cause I want to get them installed by tomorrow. Thanks a million...Pic would helpful

[454ss]

I think the 2 holes on the passenger side should line right up with the outer 2 holes from the 60/40 and you would just have to drill the 2 holes for the inner part of the buckets to fit it.

[Sailor77]

No they dont actually. All four have to be redrilled. The base tilts forward to allow access to ext cab.

[Badass69]

I dumped a set out of a 93 extended cab in my 92 reg cab that just had a regular bench and the all the out side holes lined up and I just had to drill new inside holes. Maybe your 60/40 is different, none that I have seen are, but it should just bolt up. Is this a reg cab truck you have, it shouldn't matter, either way the out side holes should align, mine did. If they don't just position the seat, line it up with the drivers and then drill, its no big deal.

[Low Lyfe]

What kind of buckets would fit in a 95 gmc sierra that I just have to drill holes?I alway sthought It would be more complicated and I thought I would have to fabricate brackets, but if i just got to drill holes i'm all for it.So what will fit?

[Low Lyfe]

^^^???