Seat Removal

[Eisenfaust]

I need to take out the seats in my reg cab chevy. I went out and looked at the bolts holding it in and the rear bolt is a male torx buts the front is strange looking. I heard you need a special tool from gm to get it out. Is this true? Where do i get it?

[Nick]

Nope, just find a socket to fit it. :D

[SportyShorty]

Ya, Im pretty sure you can get a SAE socket to fit on it pretty good. I took mine out last summer. Took about 20 minutes. Piece of cake:D

[Eisenfaust]

ok...the bolts looked a lil goofy but maybe i was just:mexsmoke:

[DMAXMAN]

yeah..these are reverse torx head I beleive. but like mentioned above you can use a regular socket

[OKLAGMCRUISER]

Pulled my front seats today...used a couple different sized sockets..front nuts were bigger than the rear bolts. Don't remember exactly what size, though, but I'm sure they were commom sizes.

[chevyman992002]

:word: you use regular sockets to get the bolts out. and remember, your seatbelt chime is hooked into the bottom of your drivers seat. I forgot about mine and kinda ripped the wire out. oops!

[aberbaseball7]

Yea, be sure to disconnect all wires underneath...

[cokedrvrbjw]

You can get the set of torx head sockets at sears for 20bucks.