Back in the air again

[aberbaseball7]

Well went from 10" and 36's to 3" body and stock tires. Got tired of that found out im moving closer to my job so she is back up in the air just a bit. I think it came out pretty good.

4" springtech spindle
3" body
Stock 4wd 2" blocks
Stock shocks up front and stock 4wd shocks in the back
33-12.50-16 STS on 16x8 classic 2's

I had to do it in the rain today but got the front done in about 4 hours and the rear in 1 and a half hours last night. I just like to take my time, also had to re-install stock shackles in the rear. Everything went well, and as long as the alignment goes well it will be all good.

All pics at http://photobucket.com/albums/v512/Aberbaseball/

http://img.photobucket.com/albums/v512/Aberbaseball/IMGP0951.jpghttp://img.photobucket.com/albums/v512/Aberbaseball/IMGP0952.jpghttp://img.photobucket.com/albums/v512/Aberbaseball/IMGP0948.jpghttp://img.photobucket.com/albums/v512/Aberbaseball/IMGP0946.jpg

[FoxTrot]

Looks good! That's too bad it rained on you but at least you got it done :)

[2K5Squirrel]

Looks good, can't wait to see some cleaned up pics. When you ordered your spindles, did they end being Full force?

[aberbaseball7]

They wasnt stamped. And are a welded peice instead of cast. Looks just like my CST spindle. But was sent in a Doetsch box. And had ground force ball joint reducers. Either way they work and fit just fine. Im happy. Just need an alignment to make sure everything is good. I also put in new used tie rods from a stock truck with low miles. So that will help since mine was worn.,

[04SilverSierra]

take out the blocks, ASS DOWN CALI STYLE

[aberbaseball7]

You are confused. Ass up Texas style...