New Engine Computers

[tom93shorty]

Im looking to put a blower on a 350 in my 93 shorty but my stock computer wont do for sure, does anyone know anything about these kinds of mods? Im looking for an effective ECM that i can tune with a laptop that will be able to control the horse power im tryin to make, id also like to try to keep all the stock sensors if i could.

[cancritter]

contact lyndon at westers he;ll get ya organized ..hes in tilley alberta
http://westers_garage.eidnet.org/index2.htm
welcome to the forums

[90C350]

Hey I would look into the new flash style EBL ecm from Dynamic EFI!!! should handle the blower no problem and will work with your stock wiring and sensors etc. You can also go to mpfi if you like and it will run that as well!! You can tune it from a laptop realtime while you drive etc. Its also going to be a plug and play ecm. I would check them out Dynamicefi cant remember the website but just google it! This is just my rec's

[Buffalo]

The website is
http://dynamicefi.com/
I think that I'll be ordering one in the next few weeks...

[Fast305]

Im looking to put a blower on a 350 in my 93 shorty but my stock computer wont do for sure, does anyone know anything about these kinds of mods? Im looking for an effective ECM that i can tune with a laptop that will be able to control the horse power im tryin to make, id also like to try to keep all the stock sensors if i could.

Actually your stock computer CAN work. I am currently testing running my TBI 350 on an 85mm GM MAF from a 5.3 truck in conjunction with a computer controlled transmission. I have everything working well using Dimented24x7's coding on the test-bed. I will be swapping to an E-trans in the next month or so (4L60E).

For a 1993 you have to deal with the E-Trans and the stock TBI PCM used on the E-Trans trucks is very tune-able and adaptable.

[davo727]

Hey Fast, Do you have a good xdf file with all the parrameters for tunerproRT for the $0D bin? I just put a new engine in my 93 C2500, I have a 16168625 PCM $E6 bin, tried $OD in it and it works but havent gotten it to run well with either bin. I have a Burn1 programmer working good. Also have an ostrich and ALDU1 but dont have them sorted out yet. Engine has a Comp Cams computer capatible flat hyd 196, 206 at .050. .425.440 lift, 112 degree LSA. iron L98 heads. ultimate TBI. It was way rich with the new engine, I leaned the main fuel table a little and that helped some. Would you have any fuel or timing suggestions for me? Thanks, Dave

[tommy2]

Where can I get a chip for my computer.....I have swap from 4.3 v6 to 5.7 v8 93 chev truck