Muskoka
06-07-2003, 11:56 PM
I just came in here from a link at another forum...looks great so far!
I'm going to be replacing my single remote cd with a new 6 disc in-dash changer from an Escalade (retaining the factory Theftlock head unit) in my 1996 Yukon and will have to cut the hard plastic bezel about 1/2 inch on each side of the existing opening to get it to fit.
What should I use to enlarge this opening so that it's nice and clean and doesn't look like I did it in the dark with a screwdriver?
I'm thinking of making a template to that I have the exact width and the roundness of the corners for the new unit then using a Dremel to very slowly increase the opening.
Any other suggestions?
I'm going to be replacing my single remote cd with a new 6 disc in-dash changer from an Escalade (retaining the factory Theftlock head unit) in my 1996 Yukon and will have to cut the hard plastic bezel about 1/2 inch on each side of the existing opening to get it to fit.
What should I use to enlarge this opening so that it's nice and clean and doesn't look like I did it in the dark with a screwdriver?
I'm thinking of making a template to that I have the exact width and the roundness of the corners for the new unit then using a Dremel to very slowly increase the opening.
Any other suggestions?